Re: P&H Injector Interface

[garwillis@msn.com (Garfield Willis)]

On Sat, 20 May 2000 16:04:16 -0700, garwillis@msn.com (Garfield Willis)
wrote:

>We have to also enumerate the number of
>driver combos to see how medusa-like this is going to become.
>...
>The goal is, for all the GM ecms, one box, one connector typeNsize,
>modular drivers inside. We'll see if that's possible; to early to tell.

This is a first-cut at the above enumeration:

On TBI ecms, I assume two wires, one for each TBI (1.2ohm, 2 mH).

On batch ecms, I assume either one wire for straight-batch of sats, OR
two wires for bank-to-bank-batch of sats.

On sequential ecms, I assume one wire per injector. If any of these wire
injectors in pairs, two inj per wire, please let me know.

Also assuming nobody's going to go below the normal TPI P&H inj specs of
2.4ohm, if they convert to P&H.

Any of this wrong? (Heh, any of it correct?).

BTW, when I said in the above goal, "one connector sizeNtype", I meant
on the *interface box* of course; no restriction on the ECM, as long as
the individual pin type is the same. Are there more than the two pin
types, BTW? Assuming one type for the batch ECMs, one for the later
sequentials.

TIA,
Gar


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org