Re: Convert 6 cyl tacho for use with 4 cyl

["Andy Whittaker - Chester UK" <arwefi@netcomuk.co.uk>]

Peter,

Obviously you need to divide by one and a half.

Use an 'edge-triggered' binary up/down counter set to count-up. This will
effectively multiply the input square-wave by two. Then, connect an AND gate
between bits 0 and 1 of the counter, this will divide by 3. This should then
give you the output you want.

Andy.
------------------------------------------
Andy Whittaker
Chester, England.
Email: gmecu@andywhittaker.com
Web: http://www.andywhittaker.com/
ECU Stuff: http://www.andywhittaker.com/ecu/


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org