[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: P&H Injector Interface



On Tue, 23 May 2000 21:00:17 -0700, "Walter Sherwin" <wsherwin@home.com>
wrote:

>Lot's of people interested in twin banks of twin TBI 4/1 amp P&H TBI
>injectors, whether Rochester or Holley (aka EV2 Bosch).  The current
>conversion options (pun intended) typically pervert many of the fundamental
>engineering criteria.

Well, wait a minuto. That's covered by two Batch P&H drivers *each*
capable of driving 4 TPI P&H injectors, idn't it? That's always been in
the plan. You mean to say that VIC thang cain't do that? Well, phhhttt
then, it's whimpy.

>>>> Also assuming nobody's going to go below the normal TPI P&H inj specs of
>>>> 2.4ohm, if they convert to P&H.
>>>
>>>Just the Holley or doing multipu TBIs  which would be 4  1.2s
>>
>>Can I reasonably blow off covering this possibility? I hope so.

The combo I was hoping to "blow off" was (4) 1.2ohm devices on ONE
driver. This case you mention above is just fine. I must have
misunderstood Bruce's response then regarding the Holley config. I'd
been harbouring the fear that people would eventually also wanna go to
TBI-sized injectors on EACH cylinder!! Kinsler has them now; they're
whoppers.

Gar


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org