[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: P&H Injector Interface

To: <gmecm@diy-efi.org>
Subject: Re: P&H Injector Interface
From: "Swayze" <kswayze@bellsouth.net>
Date: Tue, 23 May 2000 22:41:36 -0400
References: <004501bfc524$a723d0a0$12b62a18@cr29243-a.pr1.on.wave.home.com> <3ad04c76.638048476@smtp.email.msn.com>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

aside from all the practical aspects of splicing at the ECM...
I reread (quickly) the .pdf's for the LM1949 and L584(548?) and saw that the upper end of their operating temp range is 105 to 120 degC with an absolute max around 150degC, so, what would need to be done to make it (them)  heat survivable at the injector or close to it.

byE
Mike
Swayze
mswayze@truswood.com
kswayze@bellsouth.net

............

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

References:
- Re: P&H Injector Interface
  - From: "Walter Sherwin" <wsherwin@home.com>
- Re: P&H Injector Interface
  - From: garwillis@msn.com (Garfield Willis)

Prev by Date: Injectors: P&H and SAT - Part 4
Next by Date: Re: P&H Injector Interface
Previous by thread: Re: P&H Injector Interface
Next by thread: Re: P&H Injector Interface
Index(es):
- Date
- Thread