[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
cts
I am adapting a 1227747 to fit onto a jeep 258. My question regards the mounting of the coolant temp sensor. For simplicity, I can't mount the cts in the engine block or the manifold (it's unheated). I was wondering if I could mount it in the thermostat housing.
I realize that during start up that the temperature in the block vs the housing would be different due to the closed thermostat. I don't know the magnitude of the difference though. Would just mounting it in the thermostat housing be good enough?
Any opinions?
Thanks,
Omer Ozkul
obond@mit.edu
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org
- Follow-Ups:
- Re: cts
- From: Shannen Durphey <shannen@grolen.com>
- Re: cts
- From: "nacelp" <nacelp@bright.net>