Re: Injector driver

[Roger Heflin <rah@horizon.hit.net>]

http://www.hit.net/~rah/epromadaptor01.jpg

Also see 02, 03, and 04.

You will need to modify the eraser to run with the lid off and it
would probably be best to cover it with something when it is on, or at
the very least put it somewhere no one will be looking in its
direction.

				Roger

On Sat, 27 May 2000, Ludis Langens wrote:

> KasaRyan@aol.com wrote:
> > 
> > 6-I'm open to suggestions and would like to know if the prom really needs to
> > be removed from the 93&up carrier thingie to be read/programmed.  seems like
> > you could just connect the reader wires to the IDE-like connector on the
> > bottom of it.
> 
> Yup, there is no need to remove the chip from the carrier.  You just
> need to build an adapter between the plug on the carrier and your PROM burner.
> 
> You might run into some trouble fitting the carrier with chip into the
> EPROM eraser though.  This just means that you need to modify your eraser.
> 
> -- 
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> 
> 

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org