Re: Rev Limiter on '87 Corvette

["TK" <terryk@foothill.net>]

There is a rev limiter. Maybe it's just set high.

Terry

----- Original Message -----
From: Dave Zug <dzug@delanet.com>
To: <gmecm@diy-efi.org>
Sent: Monday, June 05, 2000 9:45 PM
Subject: Re: Rev Limiter on '87 Corvette


> I had often thought that if I got into this situation, I could reduce
spark
> advance so severely just before the rev limit I wanted that it would force
> the trans to shift from the drop in torque that resulted.  -  problem is
the
> spark table doesnt extend up to 6000 unless you get creative with the
> scaling in the code.
>
> I didn't know the 87 code did not support a rev limiter <???>. I think it
> must.. but if it really doesn't (it has to!) , go to 89 code and get one
of
> the available editors (FTP), pay the shareware fee ;-)  and learn how to
use
> it.... and read the archives and be careful with a new engine!
>
> If its an 87 vette, and it has a TPI on it, its got a sort-of all-metal
> rev-inhibitor system already cleverly included ;-P (the TPI)
>
>
> ----- Original Message -----
> From: Aaron G Kallotte <akallotte@juno.com>
> To: <gmecm@diy-efi.org>
> Sent: Monday, June 05, 2000 5:42 PM
> Subject: Rev Limiter on '87 Corvette
>
>
> > After my rebuild, my motor might want to spin faster than I think is
> > healthy.  I thought I had a factory rev limiter, but I've since learned
> > that it doesn't exist.  How can I burn my own rev limiter into the eprom
> > that will be gentle on the car?  Thanks
> > ________________________________________________________________
> > YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> > Juno now offers FREE Internet Access!
> > Try it today - there's no risk!  For your FREE software, visit:
> > http://dl.www.juno.com/get/tagj.
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> >
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org