Odp: Lambda sensors - Where, Why and how Much ?

["Marek Skrzypiec" <elemark@priv4.onet.pl>]

You can use any four wire 1V Lambda sensor.The differences  are only in the
type of the connector and length of the cable.If your old sensor has AMP
superseal (four male pins in line) connector you can use Bosch or NTK
sensors from Fiat/Lancia/Alfa Romeo .Bosch and NTK make many numbers of the
sensors with variable length of cable.Typical colors of the wires :
1) black-signal out
2) gray - signal ground
3)2*white- heater
Marek
----- Original Message -----
From: Malcolm Robb, LC 0112G <Webmaster@lotus-carlton.fsnet.co.uk>
To: <gmecm@diy-efi.org>
Sent: Wednesday, June 07, 2000 5:22 PM
Subject: RE: Lambda sensors - Where, Why and how Much ?


> Mine are in the engine exhaust down pipes, post turbos but pre cats if
that helps.
> Cheers,
> Malcolm Robb, LC 0112G


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org