[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Mods to '85 GM TPI ECM

To: gmecm@diy-efi.org
Subject: Re: Mods to '85 GM TPI ECM
From: Ludis Langens <ludis@cruzers.com>
Date: Fri, 23 Jun 2000 00:16:58 -0800
References: <4.2.2.20000622172555.00cf9ef0@srvr5.engin.umich.edu> <4.2.2.20000622200843.00d89690@srvr5.engin.umich.edu> <019d01bfdcb2$9a226ce0$2daeecd0@bradyiii> <3952C834.3E91C8FD@grolen.com> <022001bfdcc1$bdceaaa0$2daeecd0@bradyiii>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

Jim and Sharon Brady wrote:
> 
> I'm pretty certain it is and '85 since it has the
> Bosch MAF burn-off piggy back module.  That was only used in '85 right?

What is the number on the ECM?  Or, a simpler question, where on the ECM
is the PROM access door?  Near the non-narness end means '85, right in
the middle means '86 to '89.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

References:
- Re: Knock Sensor Question
  - From: D Kunnath <djktno@engin.umich.edu>
- Re: Knock Sensor Question
  - From: D Kunnath <djktno@engin.umich.edu>
- Mods to '85 GM TPI ECM
  - From: "Jim and Sharon Brady" <bradyiii@shore.intercom.net>
- Re: Mods to '85 GM TPI ECM
  - From: Shannen Durphey <shannen@grolen.com>
- Re: Mods to '85 GM TPI ECM
  - From: "Jim and Sharon Brady" <bradyiii@shore.intercom.net>

Prev by Date: Re: I tire of bruce plecan
Next by Date: Re: Dead EPROM programmer
Previous by thread: Re: Mods to '85 GM TPI ECM
Next by thread: Re: Mods to '85 GM TPI ECM
Index(es):
- Date
- Thread