RE: How to do 165 to 730

[Mike Rolica <mrolica@meridian-mag.com>]

	-----Original Message-----
	From:	Aaron G Kallotte [SMTP:akallotte@juno.com]
	Sent:	Friday, June 23, 2000 9:31 AM
	To:	gmecm@diy-efi.org
	Subject:	How to do 165 to 730

	If I wanted to change my 87 Vette to 730, how would I do it, in
general. 

	Do I need to change a lot of wiring/connectors?  

	No... just need to take all the pins out of the 165 harness, and put
then in the 730 connector. 
	I just use the wiring diagram  which I still have to find (think is
on ftp site) find it on 165 diag, and 730 and swap.. I used the wires for
the maf so that I did not have to add any.

	Do I need to add any
	other sensors besides the MAP?  

	Nope

	Where does the MAP go and how do I put it
	there?  
	I put mine on fire wall.. use the oem hose from map and stick it on
one of the vacume ports on ps near rear...
	FPR gets the vac signal from same spot.
	Thanks.
	________________________________________________________________
	YOU'RE PAYING TOO MUCH FOR THE INTERNET!
	Juno now offers FREE Internet Access!
	Try it today - there's no risk!  For your FREE software, visit:
	http://dl.www.juno.com/get/tagj.
	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org