[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: How to do 165 to 730



I thought the 165 and 730 connectors were the same except for the location
of about 12 pins?  You used the MAF wires for the MAP right?  Beats adding
more wire.  Sounds like alot of work to switch ECM connectors.

Jim Brady
'87 Monte SS 383 TPI 6 speed

>
> If I wanted to change my 87 Vette to 730, how would I do it, in
> general.
>
> Do I need to change a lot of wiring/connectors?
>
> No... just need to take all the pins out of the 165 harness, and put
> then in the 730 connector.
> I just use the wiring diagram  which I still have to find (think is
> on ftp site) find it on 165 diag, and 730 and swap.. I used the wires for
> the maf so that I did not have to add any.
>
> Do I need to add any
> other sensors besides the MAP?
>
> Nope
>
> Where does the MAP go and how do I put it
> there?
> I put mine on fire wall.. use the oem hose from map and stick it on
> one of the vacume ports on ps near rear...
> FPR gets the vac signal from same spot.
> Thanks.


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org