Re: How to do 165 to 730

[romans@starstream.net (Romans, Mark)]

I have a 90 ZF6 trans using the stock 90 vss feeding the 165 ecm and the
speedo runs perfect.  Maybe vet's are different.
Mark
----- Original Message -----
From: "Bruce Plecan" <nacelp@bright.net>
To: <gmecm@diy-efi.org>
Sent: Tuesday, June 27, 2000 2:21 PM
Subject: Re: How to do 165 to 730


>
> > If I wanted to change my 87 Vette to 730, how would I do it, in
> > general.
> > Do I need to change a lot of wiring/connectors?
> > No... just need to take all the pins out of the 165 harness, and put
> > then in the 730 connector.
> > I just use the wiring diagram  which I still have to find (think is
> > on ftp site) find it on 165 diag, and 730 and swap.. I used the wires
for
> > the maf so that I did not have to add any.
> > Do I need to add any
> > other sensors besides the MAP?
> > Nope
> > Where does the MAP go and how do I put it
> > there?
> > I put mine on fire wall.. use the oem hose from map and stick it on
> > one of the vacume ports on ps near rear...
> > FPR gets the vac signal from same spot.
> > Thanks.
>
> will take a *custom* chip for the VSS in you 87.
> Grumpy
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org