Re: BPW and Cylinder Vol.?

[Shannen Durphey <shannen@grolen.com>]

Funny what you can find by reading through old mail...
So you're disabling CL and watching the O2 values to determine
rich/lean?
How about Roger Heflin's suggestion to set 14.7 AFR and leave CL
enabled, using BL and INT as guidelines?
Shannen

rrauscher@nni.com wrote:
> 
> To force open loop, set the enable temp to the max value. For
> tuning the VE tables, also set the open loop afr ratio to 14.7.
> 
> On the '747 there are two tables to change, one for the afr
> vs. temp., and the other is afr vs. map. In this manner, you
> can then 'discover' what the ve is at each point in the table.
> 
> This is really tuning in reverse, but hey, it works <g>.
> 
> BobR.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org