Re: BPW and Cylinder Vol.?

[Shannen Durphey <shannen@grolen.com>]

You're talking about the values in the tables that begin at 0xC42D?
Shannen

Romans, Mark wrote:
> 
> That's what I did on my 165 to "Adjust" the maf sensor values.
> Mark
> ----- Original Message -----
> From: "Shannen Durphey" <shannen@grolen.com>
> To: <gmecm@diy-efi.org>
> Sent: Tuesday, June 27, 2000 8:24 PM
> Subject: Re: BPW and Cylinder Vol.?
> 
> > Funny what you can find by reading through old mail...
> > So you're disabling CL and watching the O2 values to determine
> > rich/lean?
> > How about Roger Heflin's suggestion to set 14.7 AFR and leave CL
> > enabled, using BL and INT as guidelines?
> > Shannen
> >
> > rrauscher@nni.com wrote:
> > >
> > > To force open loop, set the enable temp to the max value. For
> > > tuning the VE tables, also set the open loop afr ratio to 14.7.
> > >
> > > On the '747 there are two tables to change, one for the afr
> > > vs. temp., and the other is afr vs. map. In this manner, you
> > > can then 'discover' what the ve is at each point in the table.
> > >
> > > This is really tuning in reverse, but hey, it works <g>.
> > >
> > > BobR.
> > --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> >
> >
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org