RE: Quick OBD-II question, I think

["Marteney, Steven J." <smarteney@xlvision.com>]

Vehicle was just serviced by dealer.  Fixed an "alleged" manifold leak,
various other things.  SES light did not come on before service.
Steve

-----Original Message-----
From: Len Sabatine [mailto:sabatine@epix.net]
Sent: Wednesday, June 28, 2000 10:46 AM
To: gmecm@diy-efi.org
Subject: Re: Quick OBD-II question, I think


  SES Flash Codes are NLA on OBD2. Necessary to use OBD2 Scan tool to
retrieve "Codes". See if the SES clears itself in 4 drive cycles, this is
part
of the OBD2 protocol "Monitors, especially if the vehicle appears to operate
correctly with no obvious driveability problems.

Len

At 09:08 AM 6/28/00 -0400, you wrote:
>Got a friend with a 98 Malibu.  Check engine light came on this morning.
>How do you get it to flash the SES light like the old ECMs?  I'm OBD-II
>stupid!
>
>Steve
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org