Re: Q-Jet sec size

["Bruce Plecan" <nacelp@bright.net>]

I came up with a 2.060" max, but was for a 1.8"r.
On the cross fires with the 2.0" you can see light thur em <g>..
Sleepy was handling the calipers that day wo your results may vary.
Grumpy



> At 2 1/4", they are definately large enough. Maybe too large to
> fit the TBI, I'll be getting the measuring stuff out first.
>
> For a port injected system the progessive nature would be an
> advantage. I've been think of using an afb for the same reason.
>
> Thanks all for the answer,
>
> BobR.
>
> bcroe@juno.com wrote:
>
> > BobR, Those Qjets are about 1 5/16" dia primarys and
> > 2 1/4" sec.  I have considered using the throttle plate
> > from a Q jet as a throttle body to take advantage of the
> > progressive linkage.  WIth a big engine a small single
> > stage doesn't have enough flow, but a big one tends
> > to "leap" off the line.  Bruce Roe
> > ________________________________________________________________
> > YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> > Juno now offers FREE Internet Access!
> > Try it today - there's no risk!  For your FREE software, visit:
> > http://dl.www.juno.com/get/tagj.
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org