[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: ECM for forced induction



"C. Brooks" wrote:
> 
> How many different ECM's were (Can be) used for forced induction? I know of
> two, the 1227749 and the 16183247. Are there any others? Which has been
> hacked the most?

There is also the Isuzu 1.5 L4 turbo.  It uses a 1227752, but that is
just a 1227165 in a different case.  The software would work just fine
in a '7165.  A binary (ARB7887) for this application can be found on the
efi ftp site.  This setup uses a 2-bar MAP sensor.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org