Re: ECM for forced induction

["Jim and Sharon Brady" <bradyiii@shore.intercom.net>]

Ludis,
    What is a 2-bar MAP sensor.  I'm assuming one MAP table for non-spooled
supercharger and one for a spooled up supercharger?  Let me know if I am
wrong.

Jim Brady
'87 Monte SS 383 TPI 6 speed

> "C. Brooks" wrote:
> >
> > How many different ECM's were (Can be) used for forced induction? I know
of
> > two, the 1227749 and the 16183247. Are there any others? Which has been
> > hacked the most?
>
> There is also the Isuzu 1.5 L4 turbo.  It uses a 1227752, but that is
> just a 1227165 in a different case.  The software would work just fine
> in a '7165.  A binary (ARB7887) for this application can be found on the
> efi ftp site.  This setup uses a 2-bar MAP sensor.
>
> --
> Ludis Langens                               ludis (at) cruzers (dot) com
> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org