Re: VSS ?

[Bob Valentine <bob@tecmark.com>]

I thought about trying to adapt a Mopar sender from a K-car or simular.
Speedo cable just feeds thru the sensor and continues on to the mechanical
speedo in the dash.  Ford did this also, too bad GM didn't.

Found out Mopar uses a 1000ppm (1 pole) sender, so axed that....

-> Bob

At 09:16 PM 7/6/2000 -0400, you wrote:
>ECM is happy with this same signal supplied to it. I've talked to one guy
>who cut up an old speedometer, extracted the components necessary to
>generate the signal, and then installed them just behind the stock
>speedometer. Speedo cable connected to VSS parts, which then turned the
>speedo.  It sounded slightly kludged, and very dependent on available
>space, but it solved his need for VSS.

>Karl
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org