RE: VSS ?

[Mike Rolica <mrolica@meridian-mag.com>]

Wait wait....if it is like a 730 you can change the value needed I the
prom..
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 244



	-----Original Message-----
	From:	Bob Valentine [SMTP:bob@tecmark.com]
	Sent:	Friday, July 07, 2000 1:21 AM
	To:	gmecm@diy-efi.org
	Subject:	Re: VSS ?

	I thought about trying to adapt a Mopar sender from a K-car or
simular.
	Speedo cable just feeds thru the sensor and continues on to the
mechanical
	speedo in the dash.  Ford did this also, too bad GM didn't.

	Found out Mopar uses a 1000ppm (1 pole) sender, so axed that....

	-> Bob

	At 09:16 PM 7/6/2000 -0400, you wrote:
	>ECM is happy with this same signal supplied to it. I've talked to
one guy
	>who cut up an old speedometer, extracted the components necessary
to
	>generate the signal, and then installed them just behind the stock
	>speedometer. Speedo cable connected to VSS parts, which then turned
the
	>speedo.  It sounded slightly kludged, and very dependent on
available
	>space, but it solved his need for VSS.

	>Karl
	
>---------------------------------------------------------------------------
-
	>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	>in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
	>
	>
	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org