[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: LT1 files ?



With the difference being PWM TCC in the 95 vs the 94,
the only diff is the solenoid and programming then--can't see
that as a big problem other than the trouble code table.
Lyndon.
-----Original Message-----
From: Len Sabatine <sabatine@epix.net>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: July 10, 2000 7:51 AM
Subject: Re: LT1 files ?


>    Before the trail goes into a tank trap:
>   '92-3 F&Y Car use 16159278 ECM , MemCal [27256] , SD.  Thin Film RESNET
>   are different between F & Y .  Functionally not interchange.
>   '94 + Flash & MAF = 16188051 PCM , won't work in Y car.
>   16188051 used in B,D, F Platforms , calibrations "as is" aren't
>interchangeable
>   with respect to vehicle functionality , cross platform wise.
>  16181333 is Y Car PCM , will operate in F car if  overwritten with F Car
>Calibration.
>  16181333 has some OBD2 Read Only Function Monitors that  function ONLY In
>Y Platform.
>  16188051 has [ some] OBD2 code that functions in OBD1 Enviornment. [ '95
>F Car A4 ].
>   '95  A4 trans is PWM in F cars. '95 F car A4 uses 1st and 2nd Design
>Wire harness.
>   It's NOT easy ANYMORE.
>       Len
>
>><slap>
>><slap>
>>Ugh, where am I?.
>>Oh ya, who needed them
>>(Duh, Lyndon, I need your addy)
>>SD is right again
>>(hmm SD,  Speed Density?)
>>Grumpy
>>    Tired sleep nite
>>
>>
>>
>> > Y car specific, 92+93 contain eprom, 94+ is flash.
>> > Shannen
>> > Bruce Plecan wrote:
>> > > LT1 started in 92, those and 93-94 I hought were all eprom type, and
>>later
>> > > ones were the flash
>> > > Anywho, if you have a mask or ecm number maybe I can help
>> > > Grumpy
>> > > > I thought the "EE/EF" was the only one for that PCM ?
>> > > > Lyndon
>> > > > From: Bruce Plecan <nacelp@bright.net>
>> > > > Subject: Re: LT1 files ?
>> > > > >What mask ID ya looking for?
>> > > > >Grumpy
>>
>>
>>--------------------------------------------------------------------------
--
>>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org