Re: Tuning a 727 or 730 with a Supercharger

["Bruce Plecan" <nacelp@bright.net>]

Back about Mar 2000,
John Gwynne posted how to change the eprom over to a 2 bar Map, and add a
Baro input to a 730
Grumpy


> Sorry the previous post had wrong header
>
> > Anyone done any 727 or 730 programming with a Centrifugal supercharger?
I
> > just picked up a Paxton SN92 to use on my 61 Corvette. I have 1991
> Corvette
> > aluminum heads that have been pocket ported, 1991 Corvette FI setup, no
> EGR
> > no AIR. Headman Headers, no CATs, 2inch exhaust pipes back of
collectors.
> 10
> > to 1 CR. 4.11 posi in the rear and a T-56 6 speed tranny. 125hp
powershot
> > nitrous plate system. I am using TunerCat and the 8D tdf. No intercooler
> or
> > water injection yet. Comments and suggestions welcome.
> >
> > Dan Plaskett
> >
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> >
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org