Re: Accel DFI help maybe?

["Jim and Sharon Brady" <bradyiii@shore.intercom.net>]

What kind of programming can you do with this device?  What parameters can
you change and where is the change taking place(ECM or Calpak)?

Jim Brady
'87 Monte SS 383 TPI 6 speed

> I purchased a used Accel DFI "Power Programmer". This is not the stand
alone
> ECM but an Accel ECM That hooks in series with the original 86 through 89
> ECM. This came with an install manual and no Calmap instruction manual. Is
> anyone here familiar with this setup.
> I converted my 85 ECM to an 86 ECM and hooked it up. It runs but I don't
> know how to program it properly without the manual. It came with Calmap
6.0
> software.
>
> Any information on this would be appreciated.
>
> thanks
> t2k
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org