[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Accel DFI help maybe?
This system uses Calmap 5.0 software. It controls all of the fuel and WOT
spark only. According to the manual, the processor takes over spark control
at about 75% TPS, disregarding any knock sensor input. The spark control can
be left as stock if desired. The map sensor can be configured as a 1,2 or 3
bar. Open or closed loop enables, temp and rpm ranges can be defined. Nitrous
oxide settings similar to the later DFI setups is there too.
If the engine is too radical from stock, a custom chip is necessary for idle
speed control.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org