STILL trying to figure out this *&^$ 7730 and wondering if my interface
isn't at fault.
Here's the Q: Sending $F4 $57 $0A should put the ECM into Mode $0A (aka
Mode 10), which erases any malfunction codes, right?
Here's the background: It looks like I can watch serial data, but I
can't transmit to the bus. I intentionally disconnected the MAP sensor
to generated a code 34. I ran across the Mode 10 stuff on ECMGUY's page
beforehand, and tried it using PROBE with a modified request. I also
loaded ALDLMON, and while it wouldn't do anything much, I did ask it to
<E>rase Malfunction codes. It SAID it did, but I confirmed that both
PROBE and ALDLMON did not erase the codes. I did so by jumpering A & B
and watching the blinks.