[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: TPI '165 pulling timing after Cold start

To: gmecm@diy-efi.org
Subject: Re: TPI '165 pulling timing after Cold start
From: Ludis Langens <ludis@cruzers.com>
Date: Thu, 20 Jul 2000 14:50:07 -0800
References: <0907A01D587ED311BC63009027A19CC53CAE50@mpd2-nt4.meridian-mag.com> <39772192.241D8904@earthlink.net> <020501bff26f$869fe260$49258fd1@nonea878d5l7jw> <397739D9.CE8A0065@earthlink.net> <026301bff27e$04e830b0$49258fd1@nonea878d5l7jw> <39775EBE.903018DD@earthlink.net>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

Gabe wrote:
> 
> Does anyone know the application for APYN???  It was on the GMECM FTP...

1989, Camaro, 5.7, 700 R4 automatic, federal emissions, 2.77:1

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

Follow-Ups:
- Re: TPI '165 pulling timing after Cold start
  - From: Gabe <gellett@earthlink.net>

References:
- RE: was MAF BLM based tuning now cab manifold to port injection
  - From: Mike Rolica <mrolica@meridian-mag.com>
- TPI '165 pulling timing after Cold start
  - From: Gabe <gellett@earthlink.net>
- Re: TPI '165 pulling timing after Cold start
  - From: "Bruce Plecan" <nacelp@bright.net>
- Re: TPI '165 pulling timing after Cold start
  - From: Gabe <gellett@earthlink.net>
- Re: TPI '165 pulling timing after Cold start
  - From: "Bruce Plecan" <nacelp@bright.net>
- Re: TPI '165 pulling timing after Cold start
  - From: Gabe <gellett@earthlink.net>

Prev by Date: Re: 95 S-blazer base timeing
Next by Date: Re: ECU Bin Bytes 0x8000-0x8008
Previous by thread: Re: TPI '165 pulling timing after Cold start
Next by thread: Re: TPI '165 pulling timing after Cold start
Index(es):
- Date
- Thread