Re: Engine light on getting code 12

[Keith <kgil1@tampabay.rr.com>]

It looks like the chip i burnt was messed up. I reburnt it and all seems
well..
Thanks for the replies.

David Cooley wrote:
> 
> At 06:31 PM 7/30/00, you wrote:
> >This is on a 91 Syclone ECM 1227749
> >I just replaced the engine in my truck and now when I turn the key to
> >  the "on" position the check engine light comes on. I short out the A &
> >B
> >on the ALDL and get a code 12. I've checked the "M" on the ALDL and it
> >  is not shorted and has 4.8V going to it. I tried a good memcal and new
> >  ECM and i still get the same code 12.
> >  Does anyone have any suggestions on what to do now?
> >  Is there a wire that i could have disturbed while replacing the engine?
> 
> Code 12 is what you are supposed to get if all is OK...
> 
> ===========================================================
> David Cooley N5XMT Internet: N5XMT@triad.rr.com
> Packet: N5XMT@KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
> We are Borg... Prepare to be assimilated!
> ===========================================================
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org

-- 
Keith Gill F.A.S.T.
Riverview, FL
'91 GMC Syclone #2173
'75 Oldsmobile Hurst/Olds
'92 Nissan Sentra SE-R
http://www.syty.net
Direct Forum link -->>>
http://www.syty.net/cgi-bin/fast-cgi/Ultimate.cgi?action=intro
http://www.geocities.com/keith455
http://home.tampabay.rr.com/keith455
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org