Re: big inch SBC EFI intake mainfold

["Bruce Plecan" <nacelp@bright.net>]

Well, the the vette/gn has been done, so the vette/sy is open for
consideration..
That is after the Gn is making noise (howz that going?)
Grumpy


> I have the ProFlo...I liked it very well on the 355 it was on in my Vette.
> I may sell the whole damn system if the Vette sits any longer.  I've
> forgotten what it looks like with glass, an interior, and a motor.

> Kendall Frederick

> > Subject: Re: big inch SBC EFI intake mainfold
> > The Edelbrock ProFlow is a Victor Junior w/ Bungs and fuel rails
> > - It's in their
> > parts book..Tom S
> > PS I have a 406 version of your motor.
> > ECMnut@aol.com wrote:
> > > Can't you just weld some bosses for injectors onto a Victor Jr
> > > or similar flowing unit?
> > > MV


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org