Re: big inch SBC EFI intake mainfold

["Bruce Plecan" <nacelp@bright.net>]

Answering my own post <sigh>
Brain fade never mind
Grumpy

> Well, the the vette/gn has been done, so the vette/sy is open for
> consideration..
> That is after the Gn is making noise (howz that going?)
> Grumpy
>
>
> > I have the ProFlo...I liked it very well on the 355 it was on in my
Vette.
> > I may sell the whole damn system if the Vette sits any longer.  I've
> > forgotten what it looks like with glass, an interior, and a motor.
>
> > Kendall Frederick
>
> > > Subject: Re: big inch SBC EFI intake mainfold
> > > The Edelbrock ProFlow is a Victor Junior w/ Bungs and fuel rails
> > > - It's in their
> > > parts book..Tom S
> > > PS I have a 406 version of your motor.
> > > ECMnut@aol.com wrote:
> > > > Can't you just weld some bosses for injectors onto a Victor Jr
> > > > or similar flowing unit?
> > > > MV
>
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org