Re: GM calibration stuff

[romans@starstream.net (Romans, Mark)]

http://www.needhams.com/
I use an emp-10.  Relatively inexpensive and uses serial port and easy
software.
Mark
----- Original Message -----
From: "Gregg Gruen" <gruegre@hotmail.com>
To: <gmecm@diy-efi.org>
Sent: Thursday, August 03, 2000 10:45 AM
Subject: Re: GM calibration stuff


> Hello,
>
> I was on one of the teams that converted a Silverado to ethanol.  I don't
> know a whole lot about the PCM, but I know some.  And I know people that
do.
>
> I just got on this list because I'm starting to learn more about
programming
> the ECM in my truck.  I was wondering if anyone had a recommendation on a
> EPROM burner to purchase, or do you build your own?
>
> Thanks,
> Gregg Gruen
>
>
>
> >
> >Was any one around here involved with using the GM calibration stuff that
> >some colleges used for some competitions?.
> >
> >Off List response is fine..
> >Grumpy
> >
>
>---------------------------------------------------------------------------
-
> >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> >in the body of a message (not the subject) to majordomo@lists.diy-efi.org
> >
>
> ________________________________________________________________________
> Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org