[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: laptop scantool.
Hi Greg,
your ecm should be a 8192 baud, being that new.
Mike V
In a message dated 8/10/00 12:23:06 AM Eastern Daylight Time,
gruegre@hotmail.com writes:
>
> Also, I've read that some ECMs are capable of the 160 baud and the 8132
(??)
> baud. I took the liberty of running my multimeter on the E pin and I saw
> some output just as I thought I would. I ran it again on pin M not knowing
> if there would be higher baud rate output. I didn't see anything, but my
> DVM is very old and has terrible refresh rate. I'm assuming I only have
160
> baud output. If it turns out that I do have both, can I use either?
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org