Re: Vortec Throttle Body

["Jeff Kopp" <superchevyparts@mindspring.com>]

The RamJet intake is available separately. It is P/N 12489371.  If you can
find someone to sell it close to GM cost you can pick it up for around $400.
Of course, that is just the manifold.  The throttle body, rails, inj,
sensors, etc. are all extra.  I looke up about everything I could think of
that I'd need and it was around $1000.  I haven't yet ordered anything but
GM says most of it is currently available.  I can get a measurement off one
if
that will give me the indo I need.  I wasn't sure if flow capabilities (or
at least
close enough) could be determined by the size alone. -Jeff

----- Original Message -----
From: Shannen Durphey <shannen@grolen.com>
To: <gmecm@diy-efi.org>
Sent: Sunday, August 13, 2000 11:48 PM
Subject: Re: Vortec Throttle Body


> JK, do you have an intake from a ramjet 350?  Did you get one through
> traditional channels?
>
> I have traded off a vortec pickup intake w/ monoblade tb.  I'll see if
> I can remember to get some measurements next time I visit it.  I think
> it's going to see use on a 440 Chrysler blower manifold.
> Shannen
>
>


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org