Re: Vortec Throttle Body

[ECMnut@aol.com]

Are there any pic of this intake online?
Thx
MV
> 
>  The RamJet intake is available separately. It is P/N 12489371.  If you can
>  find someone to sell it close to GM cost you can pick it up for around 
$400.
>  Of course, that is just the manifold.  The throttle body, rails, inj,
>  sensors, etc. are all extra.  I looke up about everything I could think of
>  that I'd need and it was around $1000.  I haven't yet ordered anything but
>  GM says most of it is currently available.  I can get a measurement off one
>  if
>  that will give me the indo I need.  I wasn't sure if flow capabilities (or
>  at least
>  close enough) could be determined by the size alone. -Jeff
>  
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org