RE: O2 threads

[Mike Rolica <mrolica@meridian-mag.com>]

He he he.. that's sorta what I used.. the female end of a metric jic
fitting...
Had a heluva time finding a metric pipe or adj wrench to thread in the o2
sensor though..
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 244



	-----Original Message-----
	From:	Niinikoski, Juha [SMTP:Juha.Niinikoski@mikrolog.fi]
	Sent:	Wednesday, August 16, 2000 2:21 AM
	To:	'gmecm@diy-efi.org'
	Subject:	RE: O2 threads

	Recently with my Rover 3.5 efi project I had also gray hair with O2
sensor
	threads. At last I found easy and cheap solution. DIN L12 hydraulic
tube
	fittings uses same thread. From nearest hydraulic shop buy these
tube
	fitting nuts (or fittings). Shorten and fit the nut according your
exhaust
	and weld in. You can find plugs from the same place.

	Juha
	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org