Re: Fw: Rich in closed loop idle

["JN" <jwn@sgi.net>]

Well I assume there is becasue my GMEPro software has it listed as one of
the tables that can be modified.  Is this the right table?

JN
----- Original Message -----
From: <JTesta1966@aol.com>
To: <gmecm@diy-efi.org>
Sent: Wednesday, August 16, 2000 8:18 AM
Subject: Re: Fw: Rich in closed loop idle


> In a message dated 8/16/00 8:02:01 AM Eastern Daylight Time, jwn@sgi.net
> writes:
>
> <<  What table is modified to reduce the amount of fuel at open loop idle?
Is
>  > it the Open Loop AFR %Change vs. Temp?  If not what table is it?
>  >
>  > Thanks,
>  >
>  > Jason Norris >>
>
> Is there a "Low temp open loop AF ratio" in that prom?
>
> ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
> Jim  (FA) Testa                                             TType86 on
> #BuickGN
> ASE Master Technician
buick.fiendish.net:6667
> L1 Advanced Engine Performance                    NJ Lic MV Inspector
> jtesta1966@aol.com                           NJ Lic Emission Repair Tech
> http://members.aol.com/jtesta1966/buick.htm
> Associate Sponsor, Buicks at Bristol (RCA/JTP)
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org