Re: Ford injectors

[Bob Valentine <bob@tecmark.com>]

24# = light blue 
36# = dark blue

-> Bob Valentine
-> bob@tecmark.com

At 06:10 AM 8/17/2000 -0500, you wrote:
>24# SVO injectors are Blue top
>30# SVO injectors are Red top
>
>Tim
>
>At Thu, 17 Aug 2000 04:27:26 -0500, "Dan Townsend"
<xybertron@cox-internet.com> 
>wrote:
>
>>
>>The dark blue 30# svo injectors that I had did have the grooves and 
>>I got
>>them about a year ago.  I have ran the injectors without the retention 
>>clips
>>with no problems.  Just be careful when you put the rail back together 
>>not
>>to cut an o-ring like I did.  The o-rings I am talking about are part 
>>of the
>>rail assembly not the ones on the injectors.
>>
>>Also the 30# will work with a stock chip on a stock engine but don't 
>>go WOT
>>:-)
>>
>>From: "Dan Plaskett" <dynastydan@worldnet.att.net>
>>Subject: Re: Ford injectors
>>
>>
>>> Ditto on 30lb injectors on my 406 TPI 86 vette.  These did not have
>>grooves
>>> cut for the retention clips.  When first installed I had to work with 
>>them
>>> because when the fuel pump kicked on I had fuel everywhere.  Eventually
>>got
>>> them adjusted so I don't have fuel leaks but I've always been a little
>>> concerned that I might be pulling some vacuum from the bottom injector
>>seal
>>>
>>> Dan Plaskett
>>>
>>> ----- Original Message -----
>>> From: "Craig Marcho" <marcho@flash.net>
>>> To: <gmecm@diy-efi.org>
>>> Sent: Wednesday, August 16, 2000 7:26 PM
>>> Subject: RE: Ford injectors
>>>
>>>
>>> > I've put the 24lb Ford injectors on my '85 TPI 'Vette and they work
>>great.
>>> > They are shorter, but as you said, they do fit in the fuel rail 
>>enough.
>>> >
>>> > Craig M.
>>
>>--------------------------------------------------------------------
>>--------
>>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org