7730/ANHT code problem

[chetwagner@uswest.net]

Just for starters, I am in the middle of a conversion that will be 
using the 7730 and hopefully the ANHT/AUJP code.  That is if I can 
figure out why the cyl select function in the code does not work.  
No mater what the setting is set to, the engine doesn't run very well 
and the scantool always shows the rpm as if the engine is a 
V8(this is a four cyl engine it is going on).  I do not know how to 
read any of the code that is on the chip besides the data tables, 
but maybe someone who does would be able to help me.  It almost 
seems like the code was made specifically for the V8 and nothing 
else.  Please help, any little bit is more than I have.  
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org