Re: 7730/ANHT code problem

[romans@starstream.net (Romans, Mark)]

Hey Bruce:  isn't the Cyl select in the memcal too?
----- Original Message -----
From: "Bruce Plecan" <nacelp@bright.net>
To: <gmecm@diy-efi.org>
Sent: Thursday, August 17, 2000 7:46 PM
Subject: Re: 7730/ANHT code problem


> Are you using a 4 cyl memcal?.
> Bruce
>
>
> ----- Original Message -----
> From: <chetwagner@uswest.net>
> To: <gmecm@diy-efi.org>
> Sent: Thursday, August 17, 2000 10:26 PM
> Subject: 7730/ANHT code problem
>
>
> > Just for starters, I am in the middle of a conversion that will be
> > using the 7730 and hopefully the ANHT/AUJP code.  That is if I can
> > figure out why the cyl select function in the code does not work.
> > No mater what the setting is set to, the engine doesn't run very well
> > and the scantool always shows the rpm as if the engine is a
> > V8(this is a four cyl engine it is going on).  I do not know how to
> > read any of the code that is on the chip besides the data tables,
> > but maybe someone who does would be able to help me.  It almost
> > seems like the code was made specifically for the V8 and nothing
> > else.  Please help, any little bit is more than I have.
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org