Re: Injectors and AFPR

["Dan Townsend" <xybertron@cox-internet.com>]

I made my own but did it slightly different.  First remove the cap and get
rid of the safety screws and get real ones :-)  Now pound the indented top
flat and drill a hole in it.  Then scrape all the black paint off around a
1/2 inch around the hole.  Now take a wing nut and flatten the sides.  It is
for wood.  Then epoxy it in.  Now add the bolt with some red loctite and set
your pressure.  With this design I can go down to 30ish PSI with vaccum
attached and can add more pressure than my stock fuel pump can handle.

----- Original Message -----
From: "Mike Rolica" <mrolica@meridian-mag.com>
To: <gmecm@diy-efi.org>
Sent: Friday, August 18, 2000 12:02 PM
Subject: RE: Injectors and AFPR


> Build your own like I did..
>
> Take out the regulator,
> Take the black hat off.
> Drill a hole in the top.
> Weld a unf nut to it (low profile)
> And thread in a set screw
> Put it back together...
> I used  a set screw with a square head, as it is hard to get to..
> Mike Rolica
> Plant A,
> Magnesium Products Division
> Strathroy
>
> (519)-245-4040  Ext. 244
>
>
>
> -----Original Message-----
> From: Aaron G Kallotte [SMTP:akallotte@juno.com]
> Sent: Friday, August 18, 2000 12:31 PM
> To: gmecm@diy-efi.org
> Subject: Injectors and AFPR
>
> Sorry to be non ECM, but this injector thread is interesting.  I am
> planning on putting SVO 30# in my modified TPI 355.  Some have said
> that
> an adjustable fuel pressure regualtor is a valuable tuning tool
> while
> others say it causes more problems than it's worth.  Also, most
> people on
> the corvette forum use it to universally richen or lean, which I can
> do
> in the eprom in at certain rpms and loads instead of universally.
> So, is
> it worth my $70 and effort?  Thanks.
> ________________________________________________________________
> YOU'RE PAYING TOO MUCH FOR THE INTERNET!
> Juno now offers FREE Internet Access!
> Try it today - there's no risk!  For your FREE software, visit:
> http://dl.www.juno.com/get/tagj.
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
> quotes)
> in the body of a message (not the subject) to
> majordomo@lists.diy-efi.org
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org