Re: Closed Loop Disable

[ECMnut@aol.com]

In a message dated 8/18/00 8:19:35 PM Eastern Daylight Time, WEG1192@aol.com 
writes:

<< 
 How do you get the ECM to not use closed loop without a scanner? I 
 disconnected the O2 sensor but was told that that would put the ECM into 
limp 
 home mode, not open loop. My understanding was that if the ECM did not get 
 the O2 cross counts, that it would stay in open loop.
  >>
Find the "closed loop enable temp" and max it out. (FF)
HTH, Mike V
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org