Re: 16183247

["Programmer" <nwester@eidnet.org>]

Had the car here this morning...interesting memcal. It's about half
the length of a regular memcal with the ESC board over top. You've
gotta snip the legs off the ESC to erase the chip. I'll send ya the binary
tomorrow a.m.
Lyndon.
-----Original Message-----
From: Bruce Plecan <nacelp@bright.net>
To: gmecm@diy-efi.org <gmecm@diy-efi.org>
Date: August 21, 2000 8:38 AM
Subject: Re: 16183247


>
>Now ya tell me <g>
>Bruce
>
>
>----- Original Message -----
>From: "Ludis Langens" <ludis@cruzers.com>
>To: <gmecm@diy-efi.org>
>Sent: Monday, August 21, 2000 12:45 AM
>Subject: Re: 16183247
>
>
>> David Cooley wrote:
>> >
>> > Both are good Bins... I burnt them and tried them on my own 95 LeSabre
>with
>> > no problems.
>> > Tunercat may not handle the checksum on those particular bins
>properly...
>> > GM didn't always do the checksums the same.
>>
>> Buick doesn't bother with a checksum in most/all of their bins starting
>> with the P4 generation.  They also don't bother changing the mask ID in
>> new versions of the code.
>>
>> --
>> Ludis Langens                               ludis (at) cruzers (dot) com
>> Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>>
>>
>> -------------------------------------------------------------------------
-
>--
>> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>>
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org