Re: Ford injectors (& Question) MORE

["Dave Zug." <dzug@delanet.com>]

 FWIW, a reminder comment: the ford 24# ers are rated at 39 psi or so... so
I really have a little more to go.

I doubt I'll see 6000 rpm except for forgetting to shift out of the burnout
gear for the launch ;-(

Thanks all!

----- Original Message -----
From: Roger Heflin <rah@horizon.hit.net>
To: <gmecm@diy-efi.org>
Sent: Monday, August 21, 2000 11:46 PM
Subject: Re: Ford injectors (& Question) MORE

<SNIP>

> Put an intake on that motor that will let you rev and the 24# will be
> necessary.   My motor would have required right at 9ms on 24 lb
> injectors, and probably enough more to be a problem given that its
> peak hp was at 5800 and was being shifted at 6000 and usually went to
> around 6300-6400.   I just did not want to get 24# and then later need
> to upgrade them again when I rebuilt the motor (which I am doing now).
>
>
> Roger



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org