Re: Since were talking injectors......

["JN" <jwn@sgi.net>]

The motor is not build yet.  Right now its a stock 350 short block with a
Super Ram, CNC Heads and a milder cam.  pw at idle with stock injectors is
1.9-2.0.

Thanks
Jason
----- Original Message -----
From: "Dave Zug." <dzug@delanet.com>
To: <gmecm@diy-efi.org>
Sent: Friday, August 25, 2000 1:39 PM
Subject: Re: Since were talking injectors......


> Do you know at what PulseWidth your injectors run at idle? I'm curious.
>
>
> ----- Original Message -----
> From: <timsiford@hushmail.com>
> To: <gmecm@diy-efi.org>
> Sent: Thursday, August 24, 2000 3:25 PM
> Subject: Re: Since were talking injectors......
>
>
> > I just put 30lb SVO injectors in my '90 IROC (stock bottomend 350 w/ AFR
> > heads, 218/224 cam, MiniRam).  I have the FP set at 45psi and changed
the
> > injector constant to 33lb/hr.  Idles NO differently than it did with the
> > stock 22lb GM injectors.  Idles GREAT!
> >
> > Tim
> >
> >
> > At Thu, 24 Aug 2000 14:09:21 -0400, "JN" <jwn@sgi.net> wrote:
> >
> > >
> > >Here is how my 89 6 speed Vette motor will be built:
> > >
> > >383 cubic inches
> > >11:1 Compression
> > >CNC Ported L98 heads 2"/1.57" valves
> > >Lingenfelter cam .560/.560 lift 219 degrees duration
> > >Lingenfelter Super Ram intake
> > >Rear factory gears 3.33:1
> > >
> > >Looking at about 430 horsepower 470 ft lbs of torque.
> > >I have a new set of FMS 30 pound injectors.  Based on my calculations,
> > > this
> > >should be slightly on the big side.  Seems 24's are too small and 30's
> > >are
> > >too big.  I plan on changing the injector size in the E-prom to 30
lbs/hr
> > >and starting FP at 43 or so for start up.
> > >
> > >Comments on this size for pw at idle?  Does setting the injector size
> > >in the
> > >prom to say 32 have any affect?
> > >
> > >Thanks.
> > >
> > >Jason
> > >
> > >--------------------------------------------------------------------
> > >--------
> > >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
> > >in the body of a message (not the subject) to
majordomo@lists.diy-efi.org
> > >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org