Re: Cam Position Sensor

["TK" <terryk@foothill.net>]

It's where the distributor was.....

Drops into the same hole.

----- Original Message -----
From: Shawn R. Lin <slin01@mail.orion.org>
To: <gmecm@diy-efi.org>
Sent: Thursday, August 31, 2000 10:51 PM
Subject: Re: Cam Position Sensor


> Bruce Plecan wrote:
> >
> > Any one have any URLs, Pics etc, of the timing cover on a 1994  3.1 /
3.4
> > chevy motor.
>
> You might try http://members.aol.com/gpxss
> In his Pictures section, he has a lot of pictures of a 3100 V6 teardown.
> The cam position sensor is not in the timing cover though, it's in the
> block behind the timing cover.
>
> Shawn
>
>
>
> ________________________________________________________
>                            1stUp.com - Free the Web
>    Get your free Internet access at http://www.1stUp.com
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org