I left a thought out of my last post...
If indeed the BARO is not re-calculated unless the car is turned off and
back on, What happens when you start the car at the top of a mountain, and
drive down to the bottom then drive 200 miles? lotsa BLM correction?
food for thought. Maybe why they changed it later?
> Subject: use of MAP in FI calcs
>
>
> I've noticed that in most ECM's all the tables that use MAP as an index
> stop
> at 100 kPa. Since its conceivable that MAP could go above 100 kPa on a
high
> pressure day at WOT, I'm betting that the computer normalizes it with the
> barometric pressure as in mapbar = 100 * map/baro. This would account for
> the
> day to day variation in barometric pressure and normalize mapbar so that
it
> better represents true engine load. Have you guys seen any similar
> operations in your disassemblies?
> jc
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo@lists.diy-efi.org
>
>
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org