Re: Beretta PROM use...

["Bruce Plecan" <nacelp@bright.net>]

Was thinking of distributor based system and being able to use a hacd Mask
(8D).  using a HEI module to fire the two ecms is easier for those of us
with the machining capacity that an electric drill offers.

The only hard to do part of two independent systems is the TPS, course with
enough machining that can be conquered.

Just seems if there was an easy way to share stuff might be less of a MEs
job
Bruce



-> The 730 strategy would be a batch fire, and if each ecm saw 1/2 the
-> ignition pulses then you could have a dual batch fire system, but all
-> the rpm related stuff would need work.

 Hmm... how about you just mount one crank position pickup for each ECU
and let them do their own thing independently?  You'd have to mount the
wheel and make one pickup bracket anyway; making another would be no big
deal.

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org