Re: 2" butterflies on crossfire

["Bruce Plecan" <nacelp@bright.net>]

Vertical Milling machine
As far as I can measure the bores on mine are 2.00"
Some loctite

Needs to stay centered on the original bores, there ain't much wall left in
spots when done.
Bruce


Since I live in the boonies and may have to give the machine shop specific
directions on what I want done.
What is the preferred way to enlarge the TBI's?
What exact size am I looking for i.e. how much room do I need over the size
of the BFs so that they work right, but don't give me a 1500rpm idle when
closed :-)
Anything else needed other than enlarge bores and reassemble using new 2"
butterflies?

TIA,

Kevin R

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org