[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Connector pin spacing



Can anyone verify my pin spacing measurements on the PCB mount ECM
connectors?  The ECM is a 730, but should be the same on the 2 connector
ECMS as well.  I measured a pin-to-pin spacing of 0.118 which looks to be
3mm.  The row-to-row spacing measures out to be 0.151" which is not so close
to 4mm.  Anyone know what the clearance hole diameter is in the PCB?  I'm
making a circuit board to mount the PCB connector to and want to get it
right.

Steve
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org