[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Traction Control

To: gmecm@diy-efi.org
Subject: Traction Control
From: Bill Shaw <bshaw@connix.com>
Date: Tue, 19 Sep 2000 20:48:44 -0400
Organization: ww.connix.com/~bshaw/william.html
References: <200009192328.QAA30063@hektor.valesh.com>
Reply-to: gmecm@diy-efi.org
Sender: owner-gmecm@lists.diy-efi.org

Tunercat has a selection and table for traction control for my 94 Z28 which is enabled,  but traction control isn't engaged.  Does anyone know if there is an electrical switch to enable traction control?  If so on which pin does the signal enter the PCM?  I
don't see anything labeled 'Traction control' on the PCM pinout document.

Bill

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org

Follow-Ups:
- Re: Traction Control
  - From: Len Sabatine <sabatine@epix.net>

Prev by Date: Re: EFI POW WOW
Next by Date: Re: aldl stuff
Previous by thread: Injector & Coil Driver Board Group Buy
Next by thread: Re: Traction Control
Index(es):
- Date
- Thread