AFR measurement was Re: O2 voltages

[dave.williams@chaos.lrk.ar.us (Dave Williams)]

-> Sort of on topic - What do you folks (if any) use to cut the threaded
-> section OFF the spark plugs so you can see the carbon ring? Are any
-> specific manufacturers plugs easier to cut (or pop off) than others?

 I use the lathe and a cutoff tool.  You can use a Dremel and the little
abrasive cutoff wheels too; use a vise to hold the plug and hold the
Dremel with one hand bracing the other.  Sometimes the cutoff wheels
will dig in funny and get spit out in odd directions.
                                                                                          
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo@lists.diy-efi.org